LS17PEA, LS19PEA
LLS19PEB
10 Operating Instructions and Installation
10-2
4. Enter button / SOURCE button (LS19PEB)
Activates a highlighted menu item. /
Push the 'SOURCE', then selects the video signal
while the OSD is off. (When the source button is
pressed to change the input mode, a message
appears in the upper left of the screen displaying
the current mode -- analog or digital input signal.)
5. AUTO button
Use this button for auto adjustment.
6. Power button
Use this button for turn the monitor on and off.
Power indicator
This light glows green during normal operation,
and blinks green once as the monitor saves your
adjustments.
10-2 Rear
(The configuration at the back of the monitor may vary from product to product.)
1. Power port
Connect the power cord for your monitor to the power port on the back of the monitor.
2. DVI IN port
Connect the DVI cable to the DVI port on the back of your monitor.
3. RGB IN port
Connect the signal cable to the 15-pin, D-sub port on the back of your monitor.
4. Kensington Lock
The Kensington lock is a device used to physically fix the system when using it in a public place.
To Next Page
Loading...
