10 Operating Instructions and Installation
10-2
10-2 Rear
1. Power port
Connect the power cord for your monitor to the power port on the back of the monitor.
2. D-sub 15-pin port
Connect the signal cable to the 15-pin, D-sub connector on the back of your monitor.
3. Power on/off Switch(option)
Use this button for turn the monitor on and off.
4. Kensington Lock
The Kensington lock is a device used to physically fix the system when using it in a public place.
(The locking device has to be purchased separately. )
To get the information on using the Kensington Lock, contact an aurhorized dealer.
1
2
4
3
To Next Page
Loading...
