To Next PageTo Next PageHow to troubleshoot indoor temperature sensor (open/short error) -Zone2 on Samsung Heating System?
If your Samsung Heating System displays an indoor temperature sensor (open/short error) for Zone2, check the indoor unit room temperature sensor and the indoor unit PCB connector CNS043 Terminal(B15/B16).
What to do if there is a tracking error between remote controller and the Hydro unit in my Samsung AE040RXED?
If your Samsung Heat Pump displays a tracking error between the remote controller and the Hydro unit, the suggested solution is to change parts.
What does a low flow rate error mean on my Samsung AE040RXED, and how do I fix it?
If your Samsung Heat Pump displays a low flow rate error, it indicates that there is not enough water flow. The suggested action is to turn the water pump ON.
What to do if my Samsung Heat Pump shows a short- or open-circuit error for the Zone 1 indoor unit room temperature sensor?
If your Samsung Heat Pump displays a short- or open-circuit error of the room temperature sensor of the Zone 1 indoor unit (detected only when the room thermostat is used), the suggested solution is to change parts.
What to do if my Samsung AE040RXED shows a short- or open-circuit error for the Zone 2 indoor unit room temperature sensor?
If your Samsung Heat Pump displays a short- or open-circuit error of the room temperature sensor of the Zone 2 indoor unit (detected only when the room thermostat is used), the suggested solution is to change parts.
What to check when OLP overheats and compressor stops in Samsung Heating System?
If the OLP is overheated and the compressor stops in your Samsung Heating System, check the OLP sensor.
How to troubleshoot compressor V limit error on Samsung Heating System?
If your Samsung Heating System displays a compressor V limit error, check the compressor connection status and the resistance between different phases of the compressor.
What should I check for indoor unit Eva In sensor (Open/Short) error in Samsung Heating System?
If your Samsung Heating System shows an indoor unit Eva In sensor (Open/Short) error, check the indoor unit Eva in sensor location.
How to fix indoor unit communication error on Samsung Heating System?
To address an indoor unit communication error in your Samsung Heating System: * Check the communication cable of the indoor unit. * Check the DC output voltage at the communication terminal.
How to fix [Inverter] compressor startup error in Samsung Heating System?
If you're experiencing a compressor startup error on your Samsung Heating System, check the compressor connection status. Also, check the resistance between different phases of the compressor.
General| Series | AE040RXED |
|---|---|
| Category | Heat Pump |
| Cooling Capacity | 4.0 kW |
| Energy Efficiency Class (Heating) | A++ |
| Energy Efficiency Class (Cooling) | A++ |
| Refrigerant | R32 |
| Noise Level (Indoor Unit) | 21 dB(A) |
| Power Supply | 220-240V, 50Hz |
| Operating Temperature Range (Heating) | -15°C to 24°C |
| Operating Temperature Range (Cooling) | -10°C to 46°C |
