Samsung AM TNVD Series - Indoor Unit Overview (Continued); Unit Component Identification (2); Display Indicators Explained (2)

16
Installation Procedure
English
Installation Procedure
Step 13 Setting an indoor unit address
and installation option
Set the indoor unit address and installation option with
remote control option. Set the each option separately
since you cannot set the ADDRESS setting and indoor unit
installation setting option at the same time. You need to set
twice when setting indoor unit address and installation option.
Option setting procedure
Power
Mode
Fan speed
Air flow direction
(Left and right)
Options
SET
Air flow direction
(Up and down)
Temperature
Timer
Wind-Free
Direction
1 Remove batteries from the remote control.
2 Insert batteries and enter the option setting mode while
pressing
(High Temp button) and (Low Temp button).
3 Check if you have entered the option setting status.
4 After entering the option setting status, select the option.
CAUTION
• Option setting is available from SEG1 to SEG24
• SEG1, SEG7, SEG13, SEG19 are not set as page option.
• Set the SEG2~SEG6, SEG8~SEG12 as ON status and
SEG14~18, SEG20~24 as OFF status.
SEG1 SEG2 SEG3 SEG4 SEG5 SEG6
0 X X X X X
SEG7 SEG8 SEG9 SEG10 SEG11 SEG12
1 X X X X X
SEG13 SEG14 SEG15 SEG16 SEG17 SEG18
2 X X X X X
SEG19 SEG20 SEG21 SEG22 SEG23 SEG24
3 X X X X X
On (SEG1 ~ 12) Off (SEG13 ~ 24)
DB68-08953A-00_IM_DVM QMD_EU_EN_.indd 16 2020-02-10 오후 4:23:08