Samsung AM240MXVGNR/ET - Page 109

109
ENGLISH
2. Ǯ˵ʪϩ˵ʪЇϩͱΧΧʪΧɇθ˝ͱΧʪθɇϩͱѣϑ˵ʪϑࡥϩ˵ʪ˙ͱͱи˝ʒɇϩɇϑϑ˵ͱиͱϩ˵ʪͱЇϩʒͱͱθЇϩʒϑΧɇц࢏
Result Outdoor unit display Description
Setting completed End
Setting error
E191
Indoor unit data
(displayed alternately)
Indoor unit data
ৄ SEG 1,2 = indoor unit address / SEG 3,4 = error status
ߢߢࡑđAƸΧͱθϩϑͱϩ
disabled, or a pipe is
not connected.
ߢߣࡑAͱͱ˝ͱцʒͱͱθЇϩ
is connected to MCU.
ߢߤࡑƟ˵ʪϑ˵ɇθʪʒϑʪϩϩ˝˙ͱθ
two ports is incorrect.
Example) When the MCU port connected to the indoor unit 12
is disabled, E191 and 1200 are displayed alternately
ৄ If two or more indoor units have setting errors, the data about
the next indoor unit is displayed each time you press the K2
switch.
࡛If the MCU ports to use are set incorrectly, the Auto pipe pairing operation may stop due to high-pressure
or low-pressure protection control or the data about the indoor unit that has a MCU port setting error may
be incorrect. Ensure that the MCU ports to use are set correctly.
࡛Depending on the indoor and outdoor temperatures, the Auto pipe pairing operation may stop due to
protection control.
࡛If an error occurs while the Auto pipe pairing operation is running, check the error code and take actions.
࡛Ã˙цͱЇʀɇͱϩѣϑ˵ϩ˵ʪЇϩͱΧΧʪΧɇθ˝ͱΧʪθɇϩͱɵʪʀɇЇϑʪͱ˙ϩ˵ʪΧθʪЭͱЇϑθʪɇϑͱϑࡥϑʪϩϩ˵ʪΧΧʪ
addresses manually by referring to Setting the Pipe Addresses Manually.
CAUTION