Samsung Electronics
3-6
Operating Instructions and Installation
3-2-2(a) Cutting a hole and mounting installation plate
CUTTING A HOLE
Determine the pipe hole position using
the paper pattern for installation and
drill the pipe hole (65mm inner
diameter) so that it slants slightly
downward.
1. Open the Grille and remove the screw securing
the cover.
2. Firmly connect the cable connector with EL-
connector. (3pin)
3. Assembly every parts by contrary order to
disassembly.
1. Separate the cutting part of the
installation plate before installing the
installation plate.
2. Install the installation plate
horizontally on structural members
(studs, etc) in the wall.
3. To mount the installation plate on a
concrete wall with anchor bolts, utilize
the anchor bolt holes as illustrated in
the left figure.
4. When the anchor bolts are already
driven in the wall, also utilize the
anchor bolts holes to secure the
installation plate.(If an anchor bolt is
too long, adjust the projecting length to
20mm or less.)
1. When mounting installation-plate at
the window frame.
Use the paper patten for installation of
the wood pillar.
2. As the left Fig.
Fix the wood pillar at the wood frame
and install installation-plate with
screw-tap.
3. Fix the wood pillar with enough
strength to bear the weight of the
indoor unit.
MOUNTING THE INSTALLATION PLATE
Mounting at the window frame
When the installation plate is directly
mounted on the wall.
123.5mm
37mm
258.5mm
142mm
400mm
450mm
70mm
123.5mm
228.5mm
Installation plate
Anchor bolt
20mm
or less
Weight
installation plate
indoor unit
cutting part
410�730mm
Screw wood
Wood pillar
Pipe hole
(65mm)
Pipe hole(65mm)
3-2-2(b) Wiring connection (indoor unit)
To Next Page
Loading...
