Samsung Electronics
4-2
Disassembly and Reassembly
No
2
3
Electrical Parts
(Main PCB)
Heat Exchanger
9) Pull the lower part of discharge and push it
up.
1) Do “1”, above
2) Take all the connector of PCB upper side out.
3) Take display PCB and all the connector of
PCB upper side out
4) If pulling the Main PCB up. it will be taken
out.
1) Do 1 and 2, above
2) Separate the holder at the rear side of
Indoor unit.
3) Take the display PCB out.
Parts Procedure Remark
Assembling method.
●Make four brackets of the outer cover to be
hunged at the indoor unit
●Make the brackets of the outer cover of
upper center of discharge to be hunged
securely.
●Take care of not breaking away of the
opertion selection switch knob.
To Next Page
Loading...
