Samsung Electronics
4-6
Disassembly and Reassembly
No
3
4
Heat Exchanger
Compressor
3) Push the brackets of the outer cover to
separate the protection mesh from the rear
side of front cabinet.
4) Remove the nut flange (Turn to the right to
remove, as it is a left hand screw)
5) Separate the fan.
6) Loosen four fixing screws to separate the
motor.
1) Do “1”, above.
2) Loosen three fixing screws of left and front
side and separate the front cabinet.
3) Disassemble the inlet and outlet pipe by
welding.
4) Loosen one fixing screw of right side and
separate the heat exchanger.
1) Do “1”, above.
2) Open the terminal cover of compressor and
unscrew the connection terminal.
3) Disassemble the inlet and outlet pipe of
compressor by welding.
4) Disassemble the inlet and outlet pipe of
condenser by welding
5) Remove the nut flange and separate the
compressor.
Parts Procedure Remark
To Next Page
Loading...
