How to get 5.1 channel sound on Samsung DVD Player?
5.1 channel sound on your Samsung DVD player will only work if: your DVD player is connected to the correct amplifier, the disc has 5.1 channel sound, your audio system is properly connected and working, and the Audio Output in the SETUP Menu is set to Bitstream. Also, check the disc for the '5.1 ch' mark.
Why Samsung DVD-HD870 DVD Player disc does not play?
If your Samsung DVD Player isn't playing a disc, make sure the disc is inserted correctly with the label side facing up. Also, verify that the region code of the DVD matches your player.
Why is 5.1 channel sound not working on my Samsung DVD-HD870?
5. 1 channel sound on your Samsung DVD Player is only reproduced under specific conditions: * The DVD player must be connected to a compatible amplifier. * The disc must be recorded with 5.1 channel sound. Make sure the disc has the “5.1 ch” mark. Verify that your audio system is properly connected and functioning. Check in the SETUP Menu to see if the Audio Output is set to Bitstream.
Why is my Samsung DVD-HD870 remote control not working?
If your Samsung DVD Player remote control isn't working, first check and replace the batteries if needed. Ensure you are within 20 feet of the DVD player. If it still fails, try resetting the remote by removing the batteries, holding down one or more buttons for several minutes, then reinstalling the batteries.
How to reset password on Samsung DVD-HD870 DVD Player?
If you forgot the password for your Samsung DVD Player, press the button on the front panel for more than 5 seconds with no disc inside. This will revert all settings, including the password, to the factory defaults. Note: Use this as a last resort.
What to do if my Samsung DVD-HD870 disc does not play?
If your Samsung DVD Player isn't playing a disc, ensure that the disc is placed with the label side facing up. Also, verify that the region number of the DVD is compatible with your player.
What causes HDMI output Jitter on Samsung DVD-HD870?
HDMI output jitter on your Samsung DVD Player can occur if your TV system setup is incorrect or when the frame rate is converted from 50Hz to 60Hz for 720P/1080i HDMI Output. Check your TV system setup. You may also need to refer to your TV's user manual.
What to do if the picture from Samsung DVD-HD870 is noisy or distorted?
If the picture from your Samsung DVD Player is noisy or distorted, make sure the disc is clean and free of scratches. If not, clean the disc.
Why is there no HDMI output from my Samsung DVD player?
If you're getting no HDMI output from your Samsung DVD player, first check that the video output is HDMI enabled. Then, verify the connection between your TV and the HDMI jack on the DVD player. Finally, confirm that your TV supports the DVD player's resolution (480p/576p/720p/1080i).
Why does play mode differ from setup menu selection on Samsung DVD Player?
Some functions selected in the Setup Menu of your Samsung DVD Player may not work correctly if the disc is not encoded with the corresponding function.
General| Progressive scan output | Yes |
|---|---|
| Audio formats supported | MP3, WMA |
| Device type | DVD player |
| Product color | Black |
| Composite video out | 1 |
| Dimensions (WxDxH) | 430 x 210 x 43 mm |
To Next Page
