108
Settings
■ Setting smart network switch
Set whether to check availability of the connected Wi-Fi network and change
to the mobile network if it is unavailable.
1
From the Home screen, → "Settings" → "Wi-Fi"
2
"MORE"
3
"Smart network switch" → "ON"
Information
• When Wi-Fi connection is disconnected with the access point (such
as memory card with embedded wireless LAN which does not connect
to Internet) while "Smart network switch" is ON, set "Smart network
switch" to OFF.
■ Setting sleep policy of Wi-Fi
You can set to disable Wi-Fi when the display of the terminal turns o or to
set always on when charging.
1
From the Home screen, → "Settings" → "Wi-Fi"
2
"MORE"
3
"Keep Wi-Fi on during sleep"→ Select sleep policy
■ Installing a network certicate
Install a network certicate.
1
From the Home screen, → "Settings" → "Wi-Fi"
2
"MORE"
3
"Install network certicates"
■ Connecting Hotspot 2.0 compatible access point automatically
Set whether to automatically connect to Hotspot 2.0-compatible Wi-Fi
access point within the area without the Wi-Fi access point set.
1
From the Home screen, → "Settings" → "Wi-Fi"
2
"MORE"
3
"Hotspot 2.0" → "ON" → "OK"
■ Using static IP address
You can set the terminal to connect to Wi-Fi network using the static IP
address.
1
From the Home screen, → Settings" → "Wi-Fi"
2
Tap Wi-Fi network to connect → Mark "Show advanced
options"
3
Tap "IP settings eld" → "Static"
4
Set required items
• For using static IP address, enter the following items.
- IP address
- Gateway
- Network prex length
- DNS 1/DNS 2
5
"CONNECT"
■ Using Wi-Fi Direct
You can exchange data by connecting Wi-Fi Direct compatible devices.
1
From the Home screen, → "Settings" → "Wi-Fi"
2
"Wi-Fi Direct"
3
Tap a detected device name
• When the connection is accepted on the searched device, the terminal
will be connected via Wi-Fi Direct and
appears on the status bar.
■ Disconnecting Wi-Fi Direct
1
From the Home screen, → "Settings" → "Wi-Fi"
2
"Wi-Fi Direct"
3
Tap a device name to disconnect
To Next Page
Loading...
