Samsung Galaxy S7 Edge - Management; Data Bluetooth

130
Datacommunication
Datacommunication
Bluetooth
You can transfer data between the terminal and Bluetooth device
wirelessly.
• For Bluetooth compatible version or prole, see "Main specications"
(P.148).
• For setting or operations, refer to the user manual of Bluetooth device to
connect.
• The terminal does not connect wirelessly with all types of Bluetooth
devices.
■ Notes on using Bluetooth function
1. Connect the terminal to the other Bluetooth device within
approximately 10 m of vistaed distance. Depending on the
environment (wall, furniture, etc.) or structure of building, available
distance for connecting becomes short.
2. Keep more than approximately 2 m away from the other device
(electronic products, AV equipment, OA equipment etc.) and connect
it. Always keep more than approximately 3 m away from a microwave
oven because it strongly a󱐯ects the connection when it is operated.
If it is near, the connection may not be established properly when the
other device power on. Or the connection may cause noises on TV or
radio or the image may be distorted.
3. Under strong ambient signals, connection may not be established.
4. Radio waves emitted by a Bluetooth device may a󱐯ect electronic
medical equipment. Turn o󱐯 the terminal and other Bluetooth devices
in a train, aircraft or hospital, near an automatic door or re alarm,
and at a place where ammable gases are generated such as a gas
station.
■ Reception interference caused by wireless LAN devices
he terminal's Bluetooth function and wireless LAN devices use the same
frequency band (2.4 GHz). If you use the terminal near a wireless LAN
device, reception interference may occur or the communications speed
may lower. Also, you may hear noise or have a connection problem. In
these cases, do the following:
1. Keep the Bluetooth device over approximately 20 m away from a
wireless LAN device.
2. Within approximately 20 m, turn o󱐯 either the Bluetooth device or the
wireless LAN device.
■ Bluetooth pass code
Pass code is an authentication code to enter when accessing Bluetooth
devices for the rst time to recognize and permit them to connect
with each other. Entering the same pass code (up to 16 half-width
alphanumeric characters) on each sending/receiving device is required.
Entering may be required depending on the Bluetooth device.
• On the terminal, pass code may be displayed as "PIN", "passkey".
EnablingBluetoothfunctionandmakingyour
terminaldetectable
1
From the Home screen, → "Settings" → "Bluetooth"
2
Information
• When you do not use Bluetooth function, turn it OFF to save the
battery.
• The setting of the Bluetooth ON/OFF is not changed even when the
power is turned o󱐯.
Pairing/ConnectingwithBluetoothdevice
To transfer data between your terminal and other Bluetooth device, perform
paring with the device and register it to the terminal beforehand. And then
perform connection.
• Depending on Bluetooth device, only pairing may be performed or pairing and
connection may be performed successively.
• When pairing, entering the passcode (PIN) may be required depending on the
Bluetooth device.
1
From the Home screen, → "Settings" → "Bluetooth"
2
• Detected Bluetooth devices are displayed by list.
• If no Bluetooth devices are displayed, tap "SCAN" to re-search.
3
Tap a device you want to connect
4
Conrm a pass code → "OK"