Samsung HT-D7200 - Connecting Audio from External Components

English 25
02 Connections
Connecting Audio from External Components
OPTICAL : Connecting an External Digital Component
Digital signal components such as a Cable Box/Satellite receiver (Set-Top Box).
Connect the Digital Input (OPTICAL) on the product to the Digital Output of the external digital
component.
Press the FUNCTION button to select D. IN input.
The mode switches as follows :
BD/DVD  D. IN  AUX  R. iPod  HDMI1  HDMI2  TUNER
NOTE
To see video from your Cable Box/Satellite receiver, you must connect it's video output to a TV.
This system supports Digital sampling frequencies of 32 kHz of higher from external digital components.
This system supports Digital sampling frequencies of 32 kHz of higher from external digital components.
This system supports only DTS and Dolby Digital audio, MPEG audio which is bitstream cannot be supported.
AUX : Connecting an External Analogue Component
Analogue signal components such as a VCR.
Connect AUX IN (Audio) on the product to the Audio Out of the external analogue component.
Be sure to match connector colours.
Press the FUNCTION button to select AUX input.
The mode switches as follows :
BD/DVD  D. IN  AUX  R. iPod  HDMI1  HDMI2  TUNER
NOTE
You can connect the Video Output jack of your VCR to the TV, and connect the Audio Output jacks of
the VCR to this product.
1.
2.
•
✎



1.
•
2.
•
✎

SYSTEM CABLE
FM ANT
AUX IN
DIGITAL
AUDIO IN
(OPTICAL)
ONLY FOR
UPDATE
HDMI OUT HDMI IN 1 HDMI IN 2
SPEAKERS OUT
FRONTFRONT
SPEAKER IMPEDANCE : 3
SYSTEM CABLE
FM ANT
O
NLY F
OR
U
PDAT
E
HDMI
OU
T
H
DMI IN 1
H
DMI IN
2
S
PEAKER
S
OUT
IMPEDANCE
Optical Cable
(not supplied)
Audio Cable
(not supplied)
If the external analogue
component has only one Audio
Out, connect either left or right.
Set-Top Box
VCR
Red
White
OPTICALAUX
HT-D7200_ELS_1227.indd 25HT-D7200_ELS_1227.indd 25 2011-12-27  3:28:042011-12-27  3:28:04