iDCS 100 INSTALLATION
TECHNICAL MANUAL PART 2 JUNE 2002
2.6
The -48VDC cable assembly has a male 2 pin connector on the iDCS PWR. Insert this
end of the DC cable into the battery (BATT) connector found on the iDCS PWR (see
Figure 2–7)
. Attach the other end of the DC power cable to the –48VDC power source.
WARNING: Be sure the proper polarity is observed. Equipment damage will result if
polarity is reversed. Do not connect external AC or DC power to the System (see
Section 4 Power Up Procedures).
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with
the same or equivalent type recommended by the manufacturer. Dispose of used
batteries according to the manufacturer’s instructions.
To Next Page
Loading...
