iDCS 100 INSTALLATION
TECHNICAL MANUAL PART 11 JUNE 2002
11.1
PART 11. ADDING CARDS TO AN EXISTING
SYSTEM
11.1 ADDING AN SMISC CARD
1. Check the battery switch on the MEM3 or MEM4 card and make sure it is ON.
2. Turn off power to the system and unplug the power cord.
3. Insert the SMISC2 card into the slot labeled MISC.
4. Restore power to the system.
5. Open system programming and use MMC 806 to initialize the card.
6. Use MMC 724 to assign directory numbers to the ports on the card. The port
numbers and recommended directory numbers are listed in the table below. These
directory numbers are the same as the numbers that would have been assigned
when the system was first installed.
ITEM PORT NUMBER DIRECTORY NUMBER
AA PORT 1 023 381
AA PORT 2 024 382
AA PORT 3 025 383
AA PORT 4 026 384
MOH/BGM 2 027 372
PAGE OUTPUT 2 028 362
RELAY 1 029 363
RELAY 2 030 364
RELAY 3 031 365
ALARM SENSOR 032 352
11.2 ADDING A 2 SLI CARD
1. Check the battery switch on the MEM3 or MEM4 card and make sure it is ON.
2. Turn off power to the system and unplug the power cord.
3. Insert the 2 SLI card into the slot labeled SLI.
4. Restore power to the system.
5. Open system programming and use MMC 806 to initialize the card.
6. Use MMC 724 to assign directory numbers to the ports on the card. The port
numbers for the 2 SLI are listed in the following table.
To Next Page
Loading...
