iDCS 100 INSTALLATION
TECHNICAL MANUAL PART 3 JUNE 2002
3.2
3.5 SMISC2 CARD (Figure 3–5)
The Auto Attendant Message Memory backup switch should be turned ON to protect
the customer-recorded messages in the event of a power failure. This can be done
before or after the card is installed, as the switch is easily accessible. Insert the SMISC2
card into the appropriate slot (see Figure 3–1). Push firmly in the middle of both card
ejectors to ensure that it is fully inserted into the back plane connector.
NOTE: Only one SMISC1/2 card can be installed in a system.
Install the SMODEM card, if required, onto the SMISC card before installing the
SMISC card.
3.6 2 X 4 DLI CARD (Figure 3–6)
This is the same card as used on the DCS Compact. There are no options to select on
this card. Insert the 2 X 4 DLI card into any universal slot in the KSU or expansion
cabinet (see Figure 3–1). Push firmly in the middle of both card ejectors on each card
to ensure that it is fully inserted into the back plane connector.
3.7 S8DLI CARD (Figure 3–6)
There are no options to select on this card. Insert the S8DLI card into any universal slot
in the KSU or expansion cabinet (see Figure 3–1). Push firmly in the middle of both
card ejectors on each card to ensure that it is fully inserted into the back plane
connector.
3.8 2 X 4 SLI CARD (Figure 3–7)
This is the same card as used on the DCS Compact. There are no options to select on
this card. Insert the 2 X 4 SLI card into any universal slot in the KSU or expansion
cabinet (see Figure 3–1). Push firmly in the middle of both card ejectors on each card
to ensure that it is fully inserted into the back plane connector.
3.9 S8SLI CARD (Figure 3–7)
There are no options to select on this card. Insert the S8SLI card into any universal slot
in the KSU or expansion cabinet (see Figure 3–1). Push firmly in the middle of both
card ejectors on each card to ensure that it is fully inserted into the back plane
connector.
3.10 S3TRK CARD (Figure 3–8)
There are no options to select on this card. Insert the S3TRK card into any universal
slot in the KSU or expansion cabinet (see Figure 3–1). Push firmly in the middle of both
card ejectors on each card to ensure that it is fully inserted into the back plane
connector.
To Next Page
Loading...
