iDCS 100 INSTALLATION
TECHNICAL MANUAL PART 3 JUNE 2002
3.6
3.15 SPLL DAUGHTER BOARD (Figure 3–12)
There are no options to select on this card. Insert the SPLL daughter board onto its
connectors in the bottom left hand corner of the KSU motherboard (see Figure 3–13).
Push firmly in the middle of both the connectors to ensure that it is fully inserted into
the back plane connector.
3.16 MODEM CARD (Figure 3–14)
There are no options to select on this card. Install the modem card onto its connectors
on the SMISC card (see Figure 3–15). Press firmly on both corners above the
connectors to ensure that it is fully inserted on to the SMISC connectors.
3.17 IP TELEPHONY MODULE (ITMC) (Figure 3–16)
There are no options to select on the ITMC card and its capacity is 8 channels. The
card has eight (8) LEDs on its faceplate to indicate the status of the card. These
indications are described below. Insert the card into any universal card slot within the
main KSU (not expansion cabinet). See Figure 3–1. Push firmly in the middle of both
card ejectors to ensure the card is firmly seated into the back plane connector.
LED Name Function Status
PWR Power State OFF Power is OFF
ON Power is ON
RUN Processor Status OFF Power is OFF
ON Card is booting
Flicker Normal Operation
RX LAN TX State
TX LAN RX State
SPD LAN Speed OFF 10 MBPS
ON 100 MBPS
L1 Future
L2 Future
L3 Future
To Next Page
Loading...
