Samsung iDCS 100 - ATTACHING Idcs 64 B MODULES to an Idcs KEYSET

iDCS 100 INSTALLATION
TECHNICAL MANUAL PART 6 JUNE 2002
6.4
6.10 ATTACHING iDCS 64B MODULES TO AN iDCS
KEYSET
First remove the base wedge from the iDCS 64B Module and attach the bracket to it
with two of the screws provided (see Figure 6-20).
Remove the base wedge of the keyset and place it to the right of the 64 Button Module
and attach the bracket/64BM to the keyset with the remaining two screws.
The base wedge can now be replaced.
NOTE: If you wish to attach two 64 button modules to a keyset, connect the 64 button
modules together first and then attach them to the keyset.
HOME
PAGE
Table of
Contents