35
Chapter 2.
Precautions for using DP
• To increase the standby power capacity, the product stops DP communication when
it is turned off or in power saving mode.
If the product in dual monitor mode is turned off or goes into power saving mode,
monitor setting changes may not be updated. As a result, screen output may not be
displayed properly.
In the occurrence of this issue, set Max. Power Saving to Off before using the
product.
• Some graphics cards that are not compliant with the DP standard may prevent the
Windows Booting/Bios screen from being displayed when the product is in power
saving mode. If this is the case, make sure to turn on the product rst before turning
on your PC.
• The DisplayPort interface (DP IN) on the product and the provided DP cable are
designed based on the VESA standards. Using a DP cable that is not VESA compliant
may cause the product to function improperly. Samsung Electronics shall not be
held responsible for any issues from using a cable that is not VESA compliant.
Make sure to use a DP cable that is VESA compliant.
AV connection
• Do not connect the power cable before connecting all other cables.
• Ensure you connect a source device rst before connecting the power cable.
• You can connect a video device to the product using a cable.
‒ Connecting parts may differ in different products.
‒ Press the
SOURCE
button on the remote control to change the source.
Connection using an HDMI-DVI cable
The appearance may differ depending on the product.
• Audio will not be enabled if the product is connected to a video device using an
HDMI-DVI cable. To resolve this, additionally connect an audio cable to the audio
ports on the product and video device.
• After connecting a video device to the product with an HDMI-DVI cable, make sure to
congure the settings as shown below to enable the video and audio from the video
device.
‒ Sound → set HDMI Sound to AV(HDMI)
‒ Picture → set each screen mode to Videos/Images under Picture Mode
‒ System → General → set HDMI Hot Plug to On
To Next Page
Loading...
