71
Chapter 4. Remote control
Network Settings (Wired)
Connecting to a Wired Network
There are three ways to attach your product to your LAN using cable.
• You can attach your product to your LAN by connecting the LAN port on the back of
your product to an external modem using a LAN cable.
RJ45
The Modem Port
on the Wall
External Modem
(ADSL / VDSL)
Modem Cable LAN Cable
LAN
• You can attach your product to your LAN by connecting the LAN port on the back
cable for the connection.
The Modem Port
on the Wall
External Modem
(ADSL / VDSL)
IP Sharer
(having DHCP server)
LAN
Modem Cable LAN Cable LAN Cable
RJ45
•
product to your LAN by connecting the LAN port on the back of your product directly
to a network wall outlet using a LAN cable.
elsewhere in your house.
The LAN Port on the Wall
LAN
LAN Cable
RJ45
If you have a Dynamic Network, you should use an ADSL modem or router that
supports the Dynamic Host Conguration Protocol (DHCP). Modems and routers that
support DHCP automatically provide the IP address, subnet mask, gateway, and DNS
values your product needs to access the Internet so you do not have to enter them
manually. Most home networks are Dynamic Networks.
Some networks require a Static IP address. If your network requires a Static IP address,
you must enter the IP address, subnet mask, gateway, and DNS values manually on
your product Cable Setup Screen when you set up the network connection. To get
the IP address, subnet mask, gateway, and DNS values, contact your Internet Service
Provider (ISP).
If you have a Windows computer, you can also get these values through your
computer.
•
address.
•
To Next Page
Loading...
