Samsung LH55MLE - Wps(Pbc)

74
Chapter 4. Remote control
Manual Network Setup (Wireless)
Ofces may use static IP addresses.
If this is the case, ask the network administrator for the IP address, subnet mask,
gateway and DNS server address. Enter these values manually.
Getting the Network Connection Values
To view the Network connection values on most Windows computers, follow these
steps.
1 Right click the Network icon on the bottom right of the screen.
2 In the pop-up menu that appears, click Status.
3 On the dialog that appears, click the Support tab.
4 On the Support Tab, click the Details button. The Network connection values are
displayed.
How to set up manually
1 Set Network type to Wireless from the Network Settings page.
2 The Network function searches for available wireless networks. When done, it
displays a list of the available networks.
3 In the list of networks, press the  or  button to select a network, and then press
the button twice.
 If the desired wireless router does not appear, select Refresh to search again.
 If the router cannot be found after retrying, select the Stop button.
4 If the Enter password. screen appears, go to step 5. If you select a wireless router
that does not have security, go to step 7.
5 If the router has security, enter the Enter password. (Security key or PIN).
6 When done, use the right arrow button to move the cursor to Done, and then press
. The network connection screen appears and the verication process starts.
7 Select Stop while network connections are being attempted. This will stop the
connection.
8 Select IP Settings on network connection screen. The IP Settings screen appears.
9 Select the eld at the top, press E, and then set IP Settings to Enter manually.
Repeat the entry process for each eld in the IP Address.
 IP Settings to Enter manually automatically changes DNS Setting to
Enter manually.
10 When done, select OK at the bottom of the page, and then press
. The network
test screen appears and the verication process starts.
11 When the connection has been veried, the “Your wireless network and Internet
connection are setup and ready to use.” message appears.
WPS(PBC)
How to set up using WPS(PBC)
If your router has a WPS(PBC) button, follow these steps.
1 Set Network type to Wireless from the Network Settings page.
2 Select WPS(PBC), press .
3 Press the WPS(PBC) button on your router within 2 minutes. Your product
automatically acquires all the network setting values it needs and connects to your
network.
4 The network connection screen appears, and network setup is done.