73
Chapter 4. Remote control
Network Setting (Wireless)
Connecting to a Wireless Network
The LAN Port on the Wall
Wireless IP sharer
(router having DHCP server)
LAN Cable
Samsung recommends using IEEE 802.11n. When you play video over a network
connection, the video may not play smoothly.
•
channel set for the wireless IP sharer is currently being used by another device
nearby, this will result in interference and communication failure.
• Your product supports only the following wireless network security protocols.
•
• Connection Methods: You can setup the wireless network connection in three ways.
WPS(PBC)
Automatic Network Setup (Wireless)
Most wireless networks have an optional security system that requires devices
that access the network to transmit an encrypted security code called an Access or
Security Key. The Security Key is based on a Pass Phrase, typically a word or a series
of letters and numbers of a specied length you were asked to enter when you set up
security for your wireless network. If you use this method of setting up the network
connection, and have a Security Key for your wireless network, you will have to enter
the Pass Phrase during the the automatic or manual setup process.
How to set up automatically
1 Set Network type to Wireless from the Network Settings page.
2 The Network function searches for available wireless networks. When done, it
displays a list of the available networks.
3 In the list of networks, press the or button to select a network, and then press
the button twice.
If the desired wireless router does not appear, select Refresh to search again.
If the router cannot be found after retrying, select the Stop button.
The Add Network button appears.
4 If the Enter password. screen appears, go to step 5. If you select a wireless router
that does not have security, go to step 7.
5 If the router has security, enter the Enter password. (Security key or PIN).
6 When done, use the right arrow button to move the cursor to Done, and then press
. The network connection screen appears and the verication process starts.
If the product cannot connect to the Internet even though it is connected to a
router, check if the Internet connection of the router.
7 When the connection has been veried, the “Your wireless network and Internet
connection are setup and ready to use.” message appears.
To Next Page
Loading...
