Connecting the Connection Cord
The indoor unit is powered from the outdoor unit via the connection cord.
Remove the screw on the electrical component box and remove the cover
plate.
1
Route the connection cord through the side of the indoor unit and connect
the cable to terminals; refer to the figure below.
2
Route the other end of the cable to the outdoor unit through the ceiling &
the hole on the wall.
3
Reassemble the electrical component box cover, carefully tightening the
screw.
4
Between Indoor and Outdoor Connection Cord
Specifications
208-230V~
/60Hz
±10%
2.0mm
2
(H07RN-F,
3G)
Ø 1.6mm
(2 wires)
0.75~
1.25mm
2
(H07RN-F,
2 wires)
0.75~
1.25mm
2
(2 wires)
Power Supply (Single Phase)
Power Supply
Max/Min(V)
Connection Wire
Earth Cable
Communication
Cable
Home
server
CC
CC
AA
AA
UU
UU
TT
TT
II
II
OO
OO
NN
NN
Keep the power cable and the connection cord in a steel pipe to
protect them against liquids, outside impacts and so on.
E-
18
INSTALLING THE
I
NDOOR UNIT
MH***FEEA IM_E_26174 5/11/06 4:23 PM Page 18
To Next Page
Loading...
