Samsung ML-2251N/XAA - Page 54

5-16
Disassembly and Reassembly
Samsung Electronics
Service Manual
1. Before you remove the Feed Ass’y, you should
remove:
- Front Cover
- Rear Cover
- Middle Cover
- Side Cover(LH, RH)
- Top Cover
2. Disconnect the MP Solenoid and MP Sensor
harness from the main PBA. Remove the four
screws from the MP Ass'y Front and take it out
taking care to thread the cables through the
frame.
3. Remove the four screws from the MP Ass’y and
take it out.
4. Remove the two screws from the Guide Paper
Spring.
5. Remove the three screw from the Feed Bracket
and take it out.
6. Remove the Feed Gear2, as shown below.
Feed Gear2
Feed Gear2
5.16 MP Ass’y and Feed Roller
MP Ass y
Feed Bracket