Service Manual
Alignment & Adjustments
4-6
Samsung Electronics
* The procedure and content above can be changed according to the situation.
• Function
Function Name Description Display(LCD)
Fuser Fan The fan will run or stop. Fuser Fan [ON] / [OFF]
Fuser Fan Rdy Check whether the fan is in locked state. Fuser Fan Rdy.
[Ready] / [Not Ready]
SMPS Fan The fan will run or stop. SMPS Fan [ON] / [OFF]
SMPS Fan Rdy Check whether the fan is in locked state. SMPS Fan Rdy.
[Ready] / [Not Ready]
Duplex Fan The fan will run or stop. Duplex Fan [ON] / [OFF]
* The procedure and content above can be changed according to the situation.
4.1.7 Clutch / Sol
These functions are to check a current state (normal or not) of the solenoids and clutches.
• Usage
1. Press the
Arrow Keys ( ) until finding Component Test / 5.Clutch/Sol Test message on the panel.
2. Press the
OK Key , when it is found.
3. Press the
Arrow keys until finding a suitable function. (Refer to the table below)
4. Press the
OK Key , when it is found.
5. Press the
OK Key for execution or the Back key for retun.
• Function
Function Name Description Display(LCD)
T1 P-up Clutch The clutch will run or stop. T1 P-up Clutch [ON] / [OFF]
T2 P-up Clutch The clutch will run or stop. T2 P-up Clutch [ON] / [OFF]
T3 P-up Clutch The clutch will run or stop. T3 P-up Clutch [ON] / [OFF]
T4 P-up Clutch The clutch will run or stop. T4 P-up Clutch [ON] / [OFF]
Bypass Clutch The clutch will run or stop. Bypass Clutch [ON] / [OFF]
Duplex Sol. The solenoid will run or stop. Duplex Sol. [ON] / [OFF]
To Next Page
Loading...
