Alignment & Adjustments
Service Manual
4-19
Samsung Electronics
4.5 Error Messages
Messages appear on the Smart Panel program window or the control panel display to indicate the printer’s status or
errors. Refer to the tables below to understand the messages’ meaning and correct the problem if
necessary. Messages and their meanings are listed in alphabetical order.
ADC Not Confirm Error There is a problem in your printer system. Unplug the power cord and plug it back in.
If the problem persists, please call for ser-
vice.
Door Open The top cover or rear cover is not securely Close the cover until it locks into place.
latched.
Duplex Jam 0 Paper has jammed during duplex printing. Clear the jam.
Check Inside
Duplex Jam 1 Paper has jammed during duplex printing. Clear the jam.
Open/Close Door
Fuser Door Open The fuser door is not securely latched. Open the rear cover and close the fuser
door until it locks into place.
Fuser is Cleaning Your printer is printing a leaning sheet now. Please wait a few minutes.
Inner Temp. Open There is a problem in your printer system. Unplug the power cord and plug it back in.
Cycle Power If the problem persists, please call for
service.
Inner Temp. Short There is a problem in your printer system. Unplug the power cord and plug it back in.
Cycle Power If the problem persists, please call for
service.
Install Toner
A toner cartridge is not installed. Install a toner cartridge.
View of when the inner terminal of the Check if there is any deformity at the
set and the DEVE is not connected inner terminal of the set, of check the
properly. CRUM at the DEVE for any polluted
areas.
Invalid Toner The toner cartridge you have installed is Install a Samsung-genuine toner
not for your printer. cartridge, designed for your printer.
Load [Size] In [Tray] The paper size specified in the printer Load the correct paper in the tray.
properties does not match the paper you
are loading.
Load Manual The multi-purpose tray is empty in manual Load a sheet of print media and press OK.
Press Cont Key feed mode. You need to press OK each page to be
printed.
Low Heat Error There is a problem in the fuser unit. Unplug the power cord and plug it back in.
Cycle Power If the problem persists, please call for
service.
Message Meaning Suggested solutions
To Next Page
Loading...
