Setting the Clock
For each step, you have a few seconds to set the
required options. If you exceed this time, you must
start again.
1. Switch the system on by pressing the
POWER button.
2. Press TIMER/CLOCK button and then press
the ENTER button.
Result:
"CLOCK" is displayed.
3. Press ENTER.
Result:
The hour flashes.
`
Increase the hours:
▲
`
Decrease the hours:
▼
4. When the correct hour is displayed, press
ENTER.
Result:
The minutes flashes.
`
Increase the minutes:
▲
`
Decrease the minutes:
▼
5. When the correct minute is displayed, press
ENTER.
Result: " TIMER" appears in the display.
`
The current time is now set.
✎ NOTE
`
You can display the time, even when you are using another
function, by pressing the TIMER/CLOCK button once.
`
You can also use
[
or
]
on the front panel instead of
▲
,
▼
buttons in step 3,4.
Timer Function
The timer enables you to switch the system on or off
at specific times automatically.
`
Before setting the timer, check that the current time
is correct.
`
For each step, you have a few seconds to set the required
options. If you exceed this time, you must start again.
`
If you no longer want the system to switch on or off
automatically, you must cancel the timer by pressing
the TIMER ON/OFF button.
Example: You wish to wake up to music every morning.
1. Switch the system on by pressing the
POWER button.
2. Press the TIMER/CLOCK button and
then press
▲
or ▼
buttons until
TIMER is displayed.
3. Press the ENTER button.
Result: ON is displayed for a few seconds, you can set
the timer switch-on time.
4. Set the timer switch-on time.
a Press the
▲
or
▼
button.
b Press the ENTER button.
Result: The minutes flash.
c Press the
▲
or
▼
button.
d Press the ENTER button.
Result: OFF is displayed for a few seconds, you
can now set the timer switch-off time.
5. Set the timer switch-off time.
a Press the
▲
or
▼
button.
b Press the ENTER button.
Result: The minutes flash.
c Press the
▲
or
▼
button.
d Press the ENTER button.
Result: VOL XX is displayed, where XX
corresponds to the volume already set.
6. Press
▲
or
▼
button to adjust the volume level
and press the ENTER button.
Result: The source to be selected is displayed.
7. Press the
▲
or
▼
button to select the desired source
to be played when the system switches on.
`
FM (radio) : a Press the ENTER button.
b Select a preset station by press
the
▲
or
▼
button
.
`
DVD/CD (compact disc):
Load one audio CD.
`
USB : Connect the USB device.
TIMER
CLOCK
TIMER
CLOCK
To Next Page
Loading...
