Sending a fax
183
8. Faxing (Optional)
3
Adjust the document settings in the Advanced or Image tab (see
"Adjusting the document settings" on page 187).
4
Press the Basic tab.
5
Select Resolution.
6
When the cursor is blinking in the input line, enter the fax number using
the numeric keypad on the control panel. Or use Address Book from the
display screen, if you have stored frequently used fax numbers.
7
Press the Advanced tab > Delay Send.
8
Press On to active this feature.
9
Press the Job Name input area. Then the pop-up keyboard appears.
Enter the job name you want. Press Done.
If you do not enter a job name, the machine assigns the job name.
10
Set the delay sending time.
You can set the delay sending time to be greater than 15 minutes later than
the current time. For example, if it is 1:00, then you can set the time starting
to be 1:15. If the set time is incorrect, a warning message will appear when
the machine resets it to the current time.
11
Press (Start) on the control panel. The machine starts to store the
scanned original data into memory.
To cancel delaying a fax, press Off before sending is activated.
To Next Page
Loading...
Need help?
General