2-31
2. Introduction and Specication
- 이 문서는 삼성전자의 기술 자산으로 승인자만이 사용할 수 있습니다 -
- This Document can not be used without Samsung's authorization -
R530/R730
Boot Device
Boot Device Priority
Select system boot options.
NumLock
Selects Power-on state for Numlock.
Summary Screen
Display system conguration on boot.
Boot-time Diagnostic Screen
Display the diagnostic screen during boot.
PXE OPROM
This selects whether network boot PXE will be loaded or not during the POST.
- [Only with F12] : The network boot PXE will be loaded only if F12 is pressed during the POST.
- [Always] : The network boot PXE will be always loaded during the POST.
Brightness Control Mode
[Auto] : The brightness values are set by the status of AC adapter at each bootup.
[User Control] : The brightness values could be remained regardless of the status of AC adapter.
Wireless Device Control
[Always On / Off] : The wireless devices are turned on or not.
[Last Status] : The wireless devices are restored to last status.
Smart Battery Calibration
If you select this option, the system battery will be discharged completely for more accurate battery level detection. This option only
works with SMART battery.
PhoenixBIOS Setup Utility
Boot
Item Specic Help
u
Boot Device Priority
Select System boot
options
NumLock [Off]
Summary Screen [Disabled]
Boot-time Diagnostic Screen [Disabled]
PXE OPROM [Only with F12]
Brightness Mode Control [Auto]
Wireless Device Control [Always On]
Smart Battery Callbration
F1 Help
Select Item F5/F6 Change Values F9 Setup Defaults
Esc Exit
Select Menu Enter Select
Sub-Menu F10 Save and Exit
To Next Page
Loading...
Need help?
General