2. Press [2] to set Auto-Answer Mode.
3. Press [TRANSFER] to save and exit.
To Set Voice-Announce Mode
1. With the handset on-hook, press [TRANSFER] and dial [1][0] to
enter program mode.
2. Press [3] to set Voice-Announce Mode.
3. Press [TRANSFER] to save and exit.
NOTE:
The Answer Mode can be changed by caller. If the caller wants to change
the answer mode of the station called, press [ T R A N S F E R ] and dial [ 1 ] [ 4 ] .
Or, press the [ F A T ]. [ F A T ] button can be set by system key
programming (MMC 71).
On a single line telephone, hook flash and dial [1][4].
C
C
A
A
L
L
L
L
P
P
R
R
O
O
C
C
E
E
S
S
S
S
I
I
N
N
G
G
System Hold
When connected to an outside line, use this feature. It allows you to hang up
the line temporarily without disconnecting. While on hold, the held party will
hear music. Any other station may retrieve the outside line system being
held.
Keyphone
1. When connected to any outside line press [HOLD].
·The outside line button placed on hold and the HOLD indicator
blink slowly.
2. After placing a call on hold, you can answer or make another call.
3. To retrieve the held outside line, press the blinking line button.
Standard phone
1. When connected to an outside line, hook flash.
2. Press [1][1].
3. After placing a call on hold, you can answer or make another call.
CALL PROCESSING
13
본문 1999.9.15 12:32 PM 페이지15
To Next Page
Loading...
