Call accounting is accomplished using C.O. lines that report metering
pulses. The unit cost and the number of metering pulses are reported in the
SMDR output.
Keyphone
1. During any C.O. call, press [ACC], if programmed.
2. Enter an account code (up to 7 digits) maximum, including ✱ and
#. Your conversation will not be interrupted.
Standard phone
1. During any C.O. call, hookflash and dial [4][7].
2. Enter an account code (up to 7 digits), including ✱ and #.
3. Hookflash.
Ringing Line Preference
When enabled, lifting the handset or pressing [SPEAKER] will automatically
answer any call ringing at your phone.
This feature may be disabled for outside lines, allowing you to select a
ringing line by pressing the associated button. You can access other trunk
lines or make an intercom call even though an outside incoming call is
ringing on your station.
This feature only affects incoming outside calls. You may answer an
intercom call, transferred call, or recall when you lift the handset during
ringing, even though the feature is set to disable.
Refer to MMC 12 of USER PROGRAMMING.
Timer
Display keyset users may use this feature as a simple stopwatch.
Keyphone
1. Press [TMR] to start timing.
2. Press [TMR] again to stop timing.
3. Read elapsed time in display.
4. Lift handset and replace, display will return to date and time.
CONVENIENCE FEATURES
34
본문 1999.9.15 12:32 PM 페이지36
To Next Page
Loading...
