2-17
Product specifications
9. When all the adjustments are completed, complete by showing the “Calibration is Completed” message as below.
- When the “Fail” message occurs, check the connection status of the instrument or the status of the set.
10. After calibration adjustment is completed, Calibration Report is provided in the OSD menu of set.
- Menu > Picture > Calibration Report.
■ INPUT LAG
DEFINITION AND MEASUREMENT METHOD OF INPUT LAG
• INPUT LAG DEFINITION : Input delay occurs between the input signal and output from the device.
• INPUT LAG MEASURING METHOD :
1.The G75T monitor is set to 240 Hz.
2.With the signal generator, enter the TEST SIGNAL where the
white
BOX blinks as shown in the figure next to it.
3.On the screen of the monitor, INPUT LAG is measured by
measuring the time difference between input blinking and output
blinking with the optical sensor.
To Next Page
Loading...
