4-12
Troubleshooting
4-4-2. Service Function
Checking the Code Version
1. Input SVC mode and check the MCU code version and checksum.
2. Enter SVC mode.
- Set the Brightness and Contrast ratio to '0'.
- Press and hold the Enter button for 5 seconds.
- SVC Function OSD is displayed.
- Turn off the power to end SVC function.
3. Safe Mode
- When the input signal is higher than the supported frequency of the product, safe mode gives users some time
(one minute) to change the video card settings to the Recommended Mode settings.
Service Function
Monitor On Time : X Hr
← Panel information
Panel Ch. No. : 0
On Time : X Hr
Cycle : X
Pixelshift : Off ← Select the PixelShift option.
Country : English ← Country
HotPlug Time : 0
Power Off
Scaler-MCU : MSTAR MST9804 ← Counting equipment dealers
Version : M-F7724CCAA-XXXX.X ← Micom version
Checksun : 13AF ← Micom checksum
To Next Page
Loading...
