4-13
Troubleshooting
When replacing the panel
1. After replacing the panel, move to the Panel item and hold down the LEFT button for five (5) seconds.
2. The Ch. No is incremented by 1 and then both the On Time and Cycle are set to 0.
Service Function
Monitor On Time : X Hr
Panel Ch. No. : 0
← This number is incremented by 1.
On Time : X Hr
Cycle : X
Pixelshift : Off
Country : English
HotPlug Time : 0
Power Off :
:
Scaler-MCU : MSTAR MST9804
Version : M-F7724CCAA-XXXX.X
Checksun : 13AF
To Next Page
Loading...
