4-18
Troubleshooting
Entering DDC Data
winDDCU Pop-up Menus
Pop-up Menus Instructions
EDID Writer
This option writes and verifies an EDID data (*.ddc) file on the monitor via a PC.
It is mainly used to enter a single EDID data (*.ddc) file.
EDID Multi-Writer This option is used to enter details of multiple (up to 6) EDID data (*.ddc) files at the same time.
WinISP This option is used to perform a MICOM upgrade.
EEPROM Writer This option is used to perform an EEPROM upgrade.
IR Transmitter
This option creates all the IR data on the PC and transmits the data to the monitor using the
device MTI-2510.
System Upgrade This option is used to upgrade or downgrade the system version using a System Hex file.
EDID Writer Menus
Selects an input port
Loads a
*.ddc file
Starts
writing
Starts
verification
To change the mode, press Ctrl + Q
(Selection Factory Write)
To Next Page
Loading...
