4-27
Troubleshooting
Resetting MTI-2510
Sequence of switches
2
1
1. Connect MTI-2510 to the product using a USB cable, and
press switch 2.
2. With switch 2 pressed down, press switch 1 lightly and release.
Next, release switch 2.
Checklist in the occurrence of an error when entering DDC data
1. Check that the system version has been upgraded after resetting MTI-2510.
- Resetting MTI-2510 always changes the winDDCU program to the factory version 1.01 automatically.
2. Check the DDC input port (Analog, DVI, HDMI).
3. Check the DDC input file (Analog, DVI, HDMI).
4. Activate the factory (service) mode, and re-enter the DDC data.
To Next Page
Loading...
