Using Your TV as a Computer (PC) Display
Setting Up Your PC Software (Based on Windows XP)
The Windows display-settings for a typical computer are shown below. The actual screens on
your PC will probably be different, depending upon your particular version of Windows and your
particular video card. However, even if your actual screens look different, the same basic set-up
information will apply in almost all cases.
(If not, contact your computer manufacturer or Samsung Dealer.)
1. First, click on Control Panel on the Windows start menu.
2. When the control panel window appears, click on
Appearance and Themes and a display
dialog-box will appear.
3. When the control panel window appears, click on
Display and a display dialog-box will
appear.
4. Navigate to the Settings tab on the display dialog-box. The correct size setting (resolution)
Optimum: PL42B450B1 : 1024x768 pixels, PL50B450B1 : 1360x768 pixels
If a verticalfrequency option exists on your display settings dialog box, the correct value is 60
or 60 Hz. Otherwise, just click OK and exit the dialog box.
Continued...
PC Display
Changing the Mode
Provides the function to turn on the 3D Effect. You can choose between Mode1 and
Mode2. To achieve the 3D effect, the 3D glasses shutter back and forth from the left to
right and vice versa (left/right sync).
Off: Turns the 3D effect function off.
Mode1: Mode 1 operates with right sync rst.
Mode2
: Mode 2 operates with left sync rst.
2D
: Provides picture converted 3D to 2D. You can choose
this to watch 2D picture temporally when you feel dizzy, but you should
choose Off to end 3D effect completely.
You should choose Off to end 3D effect completely.
If the 3D effect is not working properly, it means the Mode and 3D glasses may not
be syncing properly. To put them in sync, switch to the other mode.
Changing the Format
Select the optimal input format to match your graphic cards or 3D software.
Checker Board: If the output format of your graphic card or 3D software is Checker
Board, select this input format.
Horizontal: If the output format of your graphic card or 3D software is Horizontal
interleaved, select this input format.
Vertical: If the output format of your graphic card or 3D software is Vertical
interleaved, select this input format.
Reset→OK/Cancel
Resets all picture settings to the default values.
Select a picture mode to be reset. The reset is performed for each picture mode.
❑
•
•
•
•
N
N
❑
•
•
•
❑
N
To Next Page
Loading...
