Pulling, pushing, or climbing on the TV may cause the TV to fall. In particular, ensure your children do not hang
over or destabilize the TV; doing so may cause the TV to tip over, causing serious injuries or death. Follow all safety
precautions provided on the included Safety Flyer. For added stability, install the anti-fall device for safety purposes,
as follows.
To avoid the TV from falling
1. Put the screws into the clamps and rmly fasten them onto the wall. Conrm that the screws
have been rmly installed onto the wall.
You may need additional material such as an anchor depending on the type of wall.
Since the necessary clamps, screws, and string are not supplied, please purchase
these additionally.
2.
Remove the screws from the center back of the TV, put the screws into the clamps, and then
fasten the screws onto the TV again.
Screws may not be supplied with the product.
3.
Connect the clamps xed onto the TV and the clamps xed onto the wall with a strong wire
and then tie the string tightly.
Install the TV near to the wall so that it does not fall backwards
.
It is safe to connect the string so that the clamps xed on the wall are equal to or lower
than the clamps xed on the TV.
Untie the string before moving the TV.
4. Verify all connections are properly secured. Periodically check connections for any sign of
fatigue or failure. If you have any doubt about the security of your connections, contact a
professional installer.
N
N
N
N
N
N
Caution
Securing the TV to the Wall
Securing the Installation Space
Keep the required distances between the product and other objects (e.g. walls) to ensure proper ventilation.
Failing to do so may result in fire or a problem with the product due to an increase in the internal temperature of the product.
Install the product so the required distances shown in the figure are kept.
When using a stand or wall-mount, use parts provided by Samsung Electronics only.
If you use parts provided by another manufacturer, it may result in a problem with the product or an injury due to the product
falling.
If you use parts provided by another manufacturer, it may result in a problem with the product or re due to an increase in the
internal temperature of the product due to poor ventilation.
The appearance may differ depending on the product.
When installing the product with a stand
When installing the product with a wall-mount
N
-
-
N
To Next Page
Loading...
