Samsung PS42B450 - Anynet+ Setup and Operation; Setting Up Anynet+; Scanning and Switching Devices

English - 32
Listening through a Receiver (Home theater)

1. Press the TOOLS button. Press the ENTER
E
button to select Anynet+ (HDMI-CEC).
2. ReceiverOn or Off.
If your receiver supports audio only, it may not appear in the device list.
N
 N


N


such as a DVD and is connected to the TV via HDMI, only 2 channel sound will be heard from the Home Theater receiver.
If there is a power interruption to the TV when the
N Receiver is set to On (by disconnecting the power cord or a power failure), the
Speaker Select may be set to External Speaker when you turn the TV on again. (see page 24)
Troubleshooting for Anynet
+
Symptom Solution
Anynet
+
does not work.   Anynet
+
device. The Anynet
+
system supports Anynet
+
devices only.
Connect only one receiver (home theater). 
  Anynet
+
device power cord is properly connected.
  Anynet
+

  Anynet
+
(HDMI-CEC) is set to On in the Anynet
+
setup menu.
 
 
+

Anynet 
+

 
or turn your TV off and on again.
 
+
Function of Anynet
+
device is set on.
I want to start Anynet
+
.  
+
Anynet
+
(HDMI-CEC) is set to On in the Anynet
+
Setup menu.
Press the  TV button on the TV remote control to switch to TV. Then press the TOOLS button
to show the Anynet
+
menu and select a menu you want.
I want to exit Anynet
+
. Select View TV in the Anynet 
+
menu.
Press the  SOURCE button on the TV remote control and select a device other than Anynet
+
devices.
(Note that the channel button operates only when a tuner-embedded Anynet 
+
device is not
connected.)
The message Connecting to
Anynet+ device...
appears on the screen.
 
+
or switching to a view
mode.
Use the remote control when the Anynet 
+
setting or switching to view mode is complete.
The Anynet
+
device does not
play.
You cannot use the play function when  Plug & Play is in progress.
The connected device is not
displayed.
 
+
functions.
 
  Anynet
+
(HDMI-CEC) is set to On in the Anynet
+
setup menu.
Search Anynet 
+
devices again.
You can connect an Anynet 
+

not support Anynet
+
functions.
If it is terminated by an abnormal situation such as disconnecting the HDMI cable or power 
cord or a power failure, please repeat the device scan.
The TV programme cannot be
recorded.
 
The TV sound is not output
through the receiver.
Connect the optical cable between TV and the receiver. 
View TV
Device List
  
DVDR MENU

   
Setup
U Move L Adjust R Return
2009-06-30 ฀฀ 10:03:03