112
Set the network connection to use Internet services such as perform software upgrades.
Automatic Open Network Settings (Wired)
How to set up automatically
1
Set Network Type to Wired from the Open Network Settings page.
2
The network test screen appears and verifies the network connection.
Success! Your device is connected to the
Internet. If you have any problems using online services, please contact your Internet
service provider.
If the connection process fails, check the LAN port connection.
If the automatic process cannot find the network connection values or if you want to set the
Manual Open Network Settings (Wired)
Offices may use static IP addresses.
DNS server address. Enter these values manually.
Getting the Network Connection Values
1
2
In the pop-up menu that appears, click Status.
3
On the dialog that appears, click the Support
4
On the SupportDetails
displayed.
How to set up manually
1
Set Network Type to Wired from the Open Network Settings page.
2
The network test screen appears and the verification process starts. Press Cancel. The
verification process stops.
3
Select IP Settings on network connection screen. The IP Settings screen appears.
4
Select the field at the top, press E, and then set IP Setting to Enter manually. Repeat the
entry process for each field in the IP Address.
Setting IP Setting to Enter manually automatically changes DNS Setting to Enter
manually.
5
OKE. The network test
screen appears and the verification process starts.
6
Success! Your device is connected to the
Internet. If you have any problems using online services, please contact your Internet
service provider.
To Next Page
Loading...
