Samsung RS261M - Inspect Ice Maker

- 11/47 -
Tip 2-4-1. Inspect self-diagnosis test
 Inspect Ice Maker
Block
① Disassemble F Ice Maker Screw Top
② Inspect Wire Harness connection which is on
The top part.
※ Ice maker test operates and water does not come,
Check TIP 2-2
※ No problem on Test and water supply, check TIP 2-5
Circuit diagram ① When Sensor failure
:Inspect No.5(WHI) + 6(WHI)
② When the Sensor is normal
: Ice Maker bottom Test
button
※ Press 2sec
③ Check ice maker operation
※Inspect Twist problem Wire
check and replace ice maker
Main PBA ① When the Sensor is failure
“CN 90”
: Inspect No.5(WHI) + 6(WHI)
② When the Ice Maker Test
operation is failure
Inspect “CN 90”
- rotate operation:
1(RED)=2(BLK)
- output sensing: 5(BLU)
- Test input: 4(S/BLU)
Sensor
Test
button
Connector
CN 90
Motor Twist
Water supply