Samsung RS261M - Inspect Lever S;W & Auger Motor S;W Operation

- 5/47 -
Step 1
① Check the Auger motor rotation sound which
is inside of F room with pushing DISPENSER
LEVER.
- When operation sound does not appear,
check Step 2
- When operation sound appears, check
“STEP 4”
Step 2
① Check Auger Motor S/W which is on the
door top of F room
- Check the S/W button with F room door
closing condition.
(Check it couldn’t push or damaged)
② After disassemble Connector and set Tester
as resistance and push S/W with hand, check
that is “0Ω”
※ It does not operate when the F room
door S/W is failure
Step 3
① After disassemble Display, push Lever and
check the Micro S/W pushing check which is
on left side.
※ Check it couldn’t push or damaged.
When there is no problem
① Check the wire Harness contact after
disassemble HINGE-UPP COVER
- Inspect No.6(YEL)and 10(GRAY) Wire
② Inspect Main PBA Connector
- Inspect CN50 No.6(YEL) and 10(GRAY)
Wire
Step 4
① Inspect less inserting of Ice Bucket.
- Pull the Bucket with pushing up toward top
※ if less inserting, Auger Motor rotation is
not passed and ice does not dispense
Check Point
Inspect Dispenser Lever S/W operation.
Tip 1-2. Inspect Lever S/W & Auger Motor S/W operation