67
System
Main menu Sub menu Settings Description
System Setup Go through the initial setup steps like you did the first time you used this product.
―
Enter your 4 digit PIN number. The default PIN number is “0-0-0-0".
If you want to change the PIN number, use the Change PIN function.
Time Clock Set Select Clock Set. Select Date or Time, and then press E.
Use the number buttons to enter numbers or press the up and down arrow buttons. Use the left and right arrow
buttons to move from one entry field to the next. Press E when done.
―
You can set the Date and Time directly by pressing the number buttons on the remote control.
DST Switches the DST (Daylight Saving Time) function on or off.
―
Start Date, End Date and Time Offset are enabled only when DST is set to Manual.
Sleep Timer Automatically shuts off the product after a preset period of time.
―
Use the up and down arrows to select a period of time, and then press E. To cancel Sleep Timer, select Off.
Auto Source Switching Auto Source Switching When the Auto Source Switching is On, the display video source will automatically be searched for active video.
The Primary Source selection will be activated, if the current video source is not recognized.
Secondary Source selection will become active, if no primary video source is available.
If both the primary and secondary input sources are not recognized, the display will perform two searches for an
active source, each search checking the primary and then secondary source. If both searches fail, the display will
return to the first video source and display a message indicating that there is no signal.
When the Primary Source selection is set to All, the display will search all the video source inputs twice in
sequence looking for an active video source, returning back to the first video source in the sequence if no video
is found.
Primary Source Recovery Select whether to restore the selected primary input source when a primary input source is connected.
―
The Primary Source Recovery function is disabled if Primary Source is set to All.
Primary Source Specify Primary Source for the automatic input source.
To Next Page
Loading...
