Troubleshooting
+ Before contacting a Samsung authorized service center, perform the following simple checks.
They may save you the time and expense of an unnecessary call.
I ENGLISH
Self Diagnosis Display
Display Blinking informs that... ' Action
slow the Battery pack is a;most discharged. Change to a charged one
Tape end! slow When the remaining time on the tape
isabout 2 minutes Prepare a new one
Tape end! no the tape reached its end Change to a new one
No Tape! slow there is no tape JnCamcorder. Insert a tape
If you want to record, release
Protection slow the tape Jsprotected from recording the protection
D slow the Camcorder has some mechanical 1 Eject the tape
fault. 2 Set to OFR
L 3 Detach the battery.
C 4 Reattach the battery.
R _ifunresolvedcontact your IocaJ
sal_sung servicecenter
slow moisture condensation has formed in see below.
the Camcorder
Moisture Condensation
+ If the Camcorder is broughtdirectly from a cold place to a warm place, moisture may condense inside the Camcorder,
on the surface of the tape, or on the lens. In this condition, the tape may stick to the head drum and be damaged or the unit
may not operate correctly.
To preventpossible damage under these circumstances, the Camcorder is fitted with a moisture sensor.
+ If there is moisture insidethe Camcorder, 1_] (DEW) is displayed. Ifthis happens, noneof the functions except cassette
ejection will work.
Open the cassette compartmentand remove the battery.
Leave the Camcorder for at least two hours in a dry warm room.
To Next Page
Loading...
