Preparing
Connecting the Power Source
22
ENGLISH
✤ There are two ways to connect power source.
- Using the AC Power Adapter : used for indoor recording.
- Using the Battery Pack: used for outdoor recording.
To use the AC Power Adapter
1. Connect the AC Power Adapter to the AC cord.
2. Connect the AC cord to a wall socket.
3. Connect the other end of the DC cable to DC jack of
the camcorder.
4. To set the camcorder to the CAMERAmode.
a. Hold down the tab of the power switch and push the switch
to CAMERAmode.
b. Set LOCK/STANDBY switch to STANDBY.
c. Make sure that the Lens Cap is open.
d. Make sure that the image appears in the Viewfinder.
Note: If the adapter is used next to a TV or the camcorder,
it may cause the TV or camcorder to emit noise.
Move the adapter away from the TV, camcorder or
the antenna cable.
1
2
3
4-a
4-b
CAMERA
STANDBY
To Next Page
Loading...
