Samsung SCP-2120 - Page 10

18_ installing your camera
installing your camera
English English _ 19
INSTALLING YOUR CAMERA
COMMUNICATION PROTOCOL DIP SWITCH
SETTINGS (SW2)
Coaxial communication automatically detects signals, and so does not require a
separate communication setup process.
Protocol Settings
Select a communication protocol for the camera
No Protocol SW2-#1 SW2-#2 SW2-#3 SW2-#4
1 AUTO DETECT OFF OFF OFF OFF
2 Samsung OFF OFF OFF ON
3 Pelco-D OFF OFF ON OFF
4 Pelco-P OFF OFF ON ON
5 Samsung Elec OFF ON OFF OFF
6 Panasonic OFF ON OFF ON
7 Vicon OFF ON ON OFF
8 Honeywell OFF ON ON ON
9 AD ON OFF OFF OFF
10 GE ON OFF OFF ON
11 BOSCH ON OFF ON OFF
12 Reserved ON OFF ON ON
13 Reserved ON ON OFF OFF
14 Reserved ON ON OFF ON
15 Reserved ON ON ON OFF
16 Reserved ON ON ON ON
Baud Rate Settings
Select the transfer speed of a selected communication protocol.
No. Baud Rate(BPS) SW2-#5 SW2-#6
1
2,400 ON ON
2
4,800 ON OFF
3
9,600 OFF OFF
4
19,200 OFF ON
*
❖
❖
ON
ON
OFF
SW2
SW2 Pin No. Purpose
1~4 Protocol Settings
5~6 Baud Rate Settings
7 Response Mode Settings
8 Termination Settings
Communication Response Settings
Select a communication response method for the camera and controller: Response or
No Response.
Function ON OFF
SW2- #7 Response Mode Switch Response No Response
Termination Settings
To prevent the attenuation of communication signals between the camera and
controller, the items at the end of line must be set up with the termination settings.
Camera Input Position SW2- #8
Termination of Longest Path ON
On the Path OFF
This model is provided with factory defaults of all DIP switches set to OFF. The default
settings are shaded in the table.
To use a third party controller with this product, please contact our After-Sales Service
or Technology Department.
Controls Using Different Protocols
AD Protocol VICON Protocol GE Protocol
Entering Camera OSD 3+Auxilary ON IRIS OPEN IRIS OPEN
Exiting Camera OSD 3+Auxilary OFF IRIS CLOSE IRIS CLOSE
ENTER IRIS OPEN IRIS OPEN IRIS OPEN
ESC IRIS CLOSE IRIS CLOSE IRIS CLOSE
For more information about the protocols, refer to our offi cial website.
CAMERA ID DIP SWITCH SETTINGS (SW1)
To set up camera IDs, refer to the “Camera ID Chart” next.
❖
❖
*
M



ON
ON
OFF
SW1