16_
installing your camera
installing your camera
English English _ 17
INSTALLING YOUR CAMERA
HOW TO SET UP PROTOCOLS AND ID DIP SWITCHES
You can control various settings of the camera system using the Communication and ID
DIP switches. Before installing the product, please set up the DIP switches according to
the installation environment.
Detach the camera frame from the install base, and place the bottom of the frame
toward you as shown in the picture below.
Set the switches according to your installation environment. For more detailed setup
information, please refer to the chart on the next page.
The camera may malfunction if the switches are not fully turned On/Off; please double
check the switches before fi nishing setup.
1.
2.
3.
Communication Protocol DIP Switch(SW2)
Camera ID DIP Switch(SW1)
Connecting with the Samsung Techwin PC DVR
· RS-485 :
Camera
PC DVR
485+
485-
+
-
SVR-9416/9116/9016
The following is a list of DVRs that can fully control the PTZ dome camera via RS-485.
- 32 Channels: SVR-3200
- 16 Channels: SVR-1680/1660/1645/1650E/1640A/9416/9116/9016
- 9 Channels: SVR-960/945/950E/940
- 4 Channels: SVR-440/450/470/480
The following is a list of Samsung Techwin DVRs that can fully control the PTZ dome
camera via a coaxial cable and RS-485.
- 16 Channels: SVR-1680C/1660C/1670
- 9 Channels: SVR-960C
※This model supports both coaxial and RS-485 communications.
M
To Next Page
Loading...
