4_ English
4.
After filling in the information, Click <OK>.
Network Setting
❒
Connection Mode
1.
Click on Network and select <Connection Mode>.
If there occur a problem with Connection Mode, check the connection
as “Installing your system” on page 1.
If you still have a problem, contact the nearest service center for more
information.
2.
Under <Connection> Tab.
Check <Connection Mode> is set to <Dynamic IP> as default.
If it connected successfully, you can see the success comment.
J If you know Static IP information from your router, please select
<Static IP> and enter IP address, Gateway, and Subnet Mask etc.
M
Please refer to the Router Guide in provided CD when you use a static IP.
3.
Under <Protocol> Tab.
J Write down your IP, Port(TCP) and Webviewer Port below.
1 IP
2 Port(TCP) 3 Webviewer Port
4.
When completing the setting, click <OK>.
1
2
3
To Next Page
Loading...
