COLOR CCD CAMERA User’s Manual
21
COLOR CCD CAMERA User’s Manual
20
Connection
Connecting to Power Configuration of The Menu
Operating Your Camera
Each model has different power specification. Please check the name of the
model and power specification before connecting to power source.
•
The wire is polarized. Be sure to connect the
wire that white line is on covering to ‘-’
terminal and connect the other one to ‘+’
terminal.
• Use AC 24V/300mA or DC 12V/500mA
power source for SHC-721AN/AP
Resistance of copper wire [at 20C˚ (68˚F)]
• As the voltage drop according to the length of the cable in the above table, a
camera may malfunction if there is an excessively long cable run.
* Voltage for camera operation: 12V DC ±10%
* Voltage drops in the above table are variable according to types of cable manufacturer.
For AC / DC Power Type
• The wire is non-polarized.
• Use AC 230V~, 50Hz power source for SHC-721APH
For High Voltage Type
Copper wire size (AWG)
#24(0.22mm
2
) #22(0.33mm
2
) #20(0.52mm
2
)#18(0.83mm
2
)
Resistance (Ω / m) 0.078 0.050 0.030 0.018
Voltage Drop (V/m) 0.028 0.018 0.011 0.006
• Be sure to connect power only after all the installation is complete.
• Note that AC or DC adaptor is not supplied with camera.
• Use the UL listed, class 2 power transformer of AC 24V adaptor.
• Ground should be connected to the GND terminal.
Notes
SETUP MENU
CAMERA ID (see page 23)
• OFF • ON
BACKLIGHT (see page 26)
• WDR • BLC • OFF
WHITE BAL. (see page 27)
• W-ATW • S-ATW • AWC • MANUAL
MOTION DET. (see page 28)
• OFF • MD1 • MD2
LENS (see page 32)
• DC / Video • Manual
SHUTTER (see page 33)
• OFF • 1/100 (1/120) • ESC • MANUAL
SENSE UP (see page 35)
• Auto • OFF
GAIN (see page 36)
• OFF • AGC-L • AGC-H
SSNR (see page 36)
• OFF • LOW • MIDDLE • HIGH
SPECIAL (see page 37)
• COLOR • SYNC • PRIVACY • PRESET
• END • EXIT
EXIT
To Next Page
Loading...
