Samsung SHC-721AH - Page 20

Operating Your Camera
COLOR CCD CAMERA User’s Manual
39
COLOR CCD CAMERA User’s Manual
38
LINE LOCK
PHASE : 225
PRESS SET TO RETURN
2. Press the SET button.
COLOR : choose color or B/W mode
- ON : color mode - OFF : B/W mode
- AUTO1 : generally color mode, B/W mode in low luminance.
- AUTO2 : AUTO2 is identical with AUTO1 under SENSE UP : AUTO condition.
SYNC : Two SYNCHRONIZATION modes are available INTERNAL and
EXTERNAL LINE-LOCK. In LINE-LOCK mode, it synchronizes the
video signal between cameras without a synchronous generator.
The line-lock synchronization is only used in the areas of 60Hz
(NTSC Models) / 50Hz (PAL Models).
- INT : Internal synchronization
- OFF : External line-lock synchronization
· If you choose ‘L/L’, you can adjust the desired phase. Press the SET button.
-You can adjust the desired phase from 0 to 270.
• When you use Auto Iris Lens with Video type, do not set the level on the lens to too
low, Color/BW may not change over automatically.
• When Gain in SET UP menu is OFF, Color / BW do not change over automatically.
• If Gain is OFF, you can select ON or OFF on COLOR menu.
• For the stable operation, whenever the mode is changed over between color and BW
mode, five setup menu buttons on the camera do not operate for about 3 seconds.
• The burst signal doesn’t come out with BW mode, so when connecting with
pheripheral equipments be sure to check the specification of those.
• The object may be more out of focus when using a source of near-infrared light
than using the visible light.
Notes
PRIVACY: To mask area which you want to mask
- OFF: Deactivation
- ON: Privacy mode activated
· Press the SET button.
· Move the arrow indicator to area you want to mask.
· Set ‘ON’ using LEFT or RIGHT button.
· Press the SET button and then set the area’s bounds with the method like
MD1 Set. (see page 29)
· When completed, press the SET button.
PRESET: To reset your camera to factory default condition
END: To move Top-menu
EXIT: To finish setting menu
• When the power frequency is 50Hz, you can not use line-lock mode(NTSC Models).
• When the power frequency is 60Hz, you can not use the line-lock mode(PAL Models).
• ‘Sync.’ mode is fixed to ‘INT’ in DC 12V input power.
Notes