CONNECTING THE RS-485 DEVICE
Caution
Please check that the RS-485 device is supported by the SHR-6040/6042 product. And, a caution shall be
made when connecting to the RS-485 jack since it has the polarity (+ and –).
CONNECTING THE USB
1. It has a total of 2 USB connection ports on the front and rear sides of SHR-6040/6042.
2. Connect the USB HDD, USB memory through the front/rear ports of SHR-6040/6042.
3. Only one USB device can be connected to each USB port.
4. It provides the hot-plugging function that allows connecting/disconnecting a USB device while operating the system.
Port for connecting the RS-485 signal
wire (connect to the RX-Receiver)
To Next Page
Loading...
